Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 91)

B-4 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
• OCL INTEGRAL GAIN (U.046)
• OCL TRIM RANGE PERCNT (U.047)
• OCL PROP TRIM ENABLE (U.048)
• Sensorless Vector Tuning
• SVC SYNC DIRECTION (U.031)
• SVC SLIP ADJUST (U.030)
• SVC FLUX REG GAIN (U.032)
• Self Tuning Parameters
• Torque Self Tune
• TORQUE SELF-TUNE RSLT (U.009)
B.1.5 Motor Data (Vector)
• MOTOR POLES (U.002)
• MOTOR NAMEPL BASE FRQ (U.003)
• MOTOR NAMEPL RPM (U.005)
• MOTOR NAMEPL HP (U.022)
• MOTOR NAMEPL VOLTS (U.007)
• MOTOR NAMEPL AMPS (U.004)
• MAGNET CURRENT PRCNT (U.006)
• ROTOR TIME CONSTANT (U.021)
B.1.6 Drive Status
• ELAPSED TIME METER (P.029)
• ELPSD TIME METER RST (P.030)
• DIAGNOSTICS SELECT (P.090)
• DIAGNOSTICS DISPLY (P.091)
• P/M OUTPUT AMPS (P.095)
• SOFTWARE VERSION NUM (P.098)
• SELECTED P/M TYPE (P.099)
B.1.7 Regulator Terminal Strip
• TS ANALOG IN OFFSET (P.009)
• TS ANALOG IN GAIN (P.010)
• TS ANALOG IN CONFIG (P.011)
• TS ANALOG OUT SOURCE (P.012)
• OUTPUT RELAY CONFIG (P.013)