Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 28)

3-8 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
Step 3. Move the cursor to Define Speed Units. Press . The Define Speed
Units screen is displayed, as shown in figure 3.5. The currently selected units
are shown on the right side of the screen.
Step 4. Move the cursor to the units of measure that you want. Press
If you selected RPM (Vector), HERTZ (V/Hz), or % (Both): The units are
changed and you are returned to the previous screen
If you selected OTHER: See section 3.5.2.
3.5.2 Setting OTHER Speed Units
If you selected OTHER for the speed units, the Define Units Tag screen is displayed,
as shown in figure 3.6.
Figure 3.5 – Define Speed Units Screen - Vector Regulation
.
!
ATTENTION: If you exit from the procedure for setting OTHER speed
units before completing it, incorrect values might be displayed for the
parameters and displays affected by scaling. If you exit before
completion, repeat the Define Speed Units procedure above to reset
the scaling to RPM, HERTZ, or %, as appropriate for your application.
Failure to observe this precaution could result in damage to, or
destruction of, the equipment.
Figure 3.6 – Define Speed Units Tag Screen