Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 71)

A-2 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
AVOID FREQ ENABLE Avoidance Frequency
Enable Input H.009 Application Setup
(V/Hz)
⇒
Avoidance
Frequencies
AVOID FREQ
MIDPOINT 1 Avoidance Frequency
Midpoint 1 Input H.010 Application Setup
(V/Hz)
⇒
Avoidance
Frequencies
AVOID FREQ
MIDPOINT 2 Avoidance Frequency
Midpoint 2 Input H.012 Application Setup
(V/Hz)
⇒
Avoidance
Frequencies
AVOID FREQ
MIDPOINT 3 Avoidance Frequency
Midpoint 3 Input H.014 Application Setup
(V/Hz)
⇒
Avoidance
Frequencies
CARRIER FREQ - KHZ Carrier Frequency (kHz) Input P.047 Application Setup
(V/Hz and Vector)
CURRENT
COMPOUND GAIN* Current Compounding
Gain Input U.026 Performance Tuning
(Vector)
⇒
Speed Loop
Tuning
CURRENT LIMIT Current Limit Input P.005 Application Setup
(V/Hz and Vector)
Quick Start
(V/Hz and Vector)
DC BRAKING ENABLE DC Braking Enable Input H.005 Application Setup
(V/Hz)
⇒
DC Braking
DC BRAKING START
FREQ DC Braking Start
Frequency Input H.006 Application Setup
(V/Hz)
⇒
DC Braking
DC BRAKING TIME DC Braking Time Input H.008 Application Setup
(V/Hz)
⇒
DC Braking
DC BRAKING
CURRENT* DC Braking Current Input H.007 Application Setup
(V/Hz)
⇒
DC Braking
DECEL TIME Decel Time 1 (RAMP 1) Input P.002 Speed Control
⇒
Accel & Decel Times
Quick Start (V/Hz and
Vector)
DECEL TIME -
SECONDARY Decel Time 2 (RAMP 2) Input P.018 Speed Control
⇒
Accel & Decel Times
DEFAULTS TYPE Country Defaults Input P.049 Memory Functions
DIAGNOSTICS DISPLY Diagnostics Display Input P.091 Drive Status
DIAGNOSTICS SELECT Diagnostics Source Input P.090 Drive Status
DRAW GAIN PERCENT Draw Gain Percentage Input P.016 Speed Control
⇒
Draw
& Trim Configure
ELAPSED TIME METER Elapsed Time Meter Read only P.029 Drive Status
ELPSD TIME METER
RST Elapsed Time Meter
Reset Input P.030 Drive Status
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path