Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 80)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-11
RMI TRQ DET LEVEL 2 Torque Detection
Level 2 Input r.064 Option Port
Configuration
⇒
RMI
Outputs
⇒
RMI Torque
Compare Levels
RMI TRQ DET LEVEL 3 Torque Detection
Level 3 Input r.065 Option Port
Configuration
⇒
RMI
Outputs
⇒
RMI Torque
Compare Levels
RMI TRQ/CURR LIM
SRC Torque/Current Limit
Source Input r.025 Option Port
Configuration
⇒
RMI
Inputs
ROTOR TIME
CONSTANT Rotor Time Constant Input U.021 Motor Data (Vector)
S-CURVE ENABLE S-Curve Enable Input P.019 Speed Control
SELECTED P/M TYPE Power Module Type Read only P.099 Drive Status
SLIP COMPENSATION Slip Compensation Input H.004 Performance Tuning
(V/Hz)
SOFTWARE VERSION
NUM Software Version
Number Read only P.098 Drive Status
SPEED REG INT GAIN Speed Regulator
Integral Gain Input U.013 Performance Tuning
(Vector)
⇒
Speed Loop
Tuning
SPEED REG PROP
GAIN Speed Regulator
Proportional Gain Input U.012 Performance Tuning
(Vector)
⇒
Speed Loop
Tuning
STOP/RST KEY
DISABLE* STOP/RESET Key
Disable Input P.055 Application Setup (V/Hz
and Vector)
STOP TYPE Stop Type Input P.025 Application Setup
(V/Hz and Vector)
SVC FLUX REG GAIN* SVC Flux Current
Regulator Gain Input U.032 Performance Tuning
(Vector)
⇒
Sensorless
Vector Tuning
SVC SLIP ADJUST* SVC Slip Adjust Input U.030 Performance Tuning
(Vector)
⇒
Sensorless
Vector Tuning
SVC SYNC
DIRECTION* SVC Sync Direction Input U.031 Performance Tuning
(Vector)
⇒
Sensorless
Vector Tuning
SYNC DIRECTION Sync Direction Input H.016 Performance Tuning
(V/Hz)
TORQUE BOOST
VOLTAGE Torque Boost Voltage Input H.003 Application Setup
(V/Hz)
TORQUE REF SOURCE
SEL Torque Reference
Source Input U.000 Application Setup
(Vector)
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path