Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 82)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-13
Table A.2 – OIM Parameters Listed by Parameter Number
Parameter Number OIM Parameter Name
P.000 CONTROL SOURCE SEL
P.001 ACCEL TIME
P.002 DECEL TIME
P.003 MINIMUM SPEED
P.004 MAXIMUM SPEED
P.005 CURRENT LIMIT
P.007 TS DIG INPUT CONFIG
P.008 TS SPEED REF SEL
P.009 TS ANALOG IN OFFSET
P.010 TS ANALOG IN GAIN
P.011 TS ANALOG IN CONFIG
P.012 TS ANALOG OUT SOURCE
P.013 OUTPUT RELAY CONFIG
P.014 TRIM REF SOURCE
P.015 TRIM GAIN PERCENT
P.016 DRAW GAIN PERCENT
P.017 ACCEL TIME - SECONDARY
P.018 DECEL TIME - SECONDARY
P.019 S-CURVE ENABLE
P.020 JOG SPEED REFERENCE
P.021 JOG RAMP ACCEL TIME
P.022 JOG RAMP DECEL TIME
P.023 MOP ACCEL DECEL TIME
P.024 MOP RESET CONFIG
P.025 STOP TYPE
P.026 FUNCT LOSS RESPONSE
P.027 FORWARD/REV CONFIGURE
P.028 FRONT PNL SPD SCALING
P.029 ELAPSED TIME METER
P.030 ELPSD TIME METER RST
P.031 PRESET SPEED 1
P.032 PRESET SPEED 2
P.033 PRESET SPEED 3
P.034 PRESET SPEED 4
P.035 PRESET SPEED 5
P.036 PRESET SPEED 6