Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 89)

B-2 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
• DECEL TIME (P.002)
• MINIMUM SPEED (P.003)
• MAXIMUM SPEED (P.004)
• CURRENT LIMIT (P.005)
• Torque Self Tune
• MAGNET CURRENT PRCNT (U.006) (Displayed only if torque self tune is not
selected.)
B.1.2 Speed Control
• Define Speed Units
• Speed Limits
• MINIMUM SPEED (P.003)
• MAXIMUM SPEED (P.004)
• Accel & Decel Times
• ACCEL TIME (P.001)
• DECEL TIME (P.002)
• ACCEL TIME - SECONDARY (P.017)
• DECEL TIME - SECONDARY (P.018)
• FORWARD/REV CONFIGURE (P.027)
• Draw & Trim Configure
• TRIM REF SOURCE (P.014)
• DRAW GAIN PERCENT (P.016)
• TRIM GAIN PERCENT (P.015)
• S-CURVE ENABLE (P.019)
• Jog Configure
• JOG SPEED REFERENCE (P.020)
• JOG RAMP ACCEL TIME (P.021)
• JOG RAMP DECEL TIME (P.022)
• FRONT PNL SPD SCALING (P.028)
B.1.3 Application Setup (Vector)
• CURRENT LIMIT (P.005)
• LEVEL SENSE START EN (P.054)
• STOP TYPE (P.025)
• ZERO SPEED HOLD TIME (U.025)
• TORQUE REF SOURCE (U.000)
• ENCODER PPR (U.001)