Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 75)

A-6 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
OCL LEAD/LAG RATIO* Outer Control Loop
Lead/Lag Ratio Input U.043 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL LEAD/LAG
SELECT* Outer Control Loop
Lead/Lag Select Input U.041 Performance Tuning
(Vector)
OCL PROPORTIONAL
GAIN* Outer Control Loop
ProportionalGain Input U.045 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL PROP TRIM
ENABLE* Outer Control Loop
Proportional Trim
Enable Input U.048 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL REFERENCE
GAIN* Outer Control Loop
Reference Gain Input U.044 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL TRIM RANGE
PERCNT* Outer Control Loop Trim
Range Percentage Input U.047 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OUTPUT PHASE LOSS
EN Output Phase Loss
Enable Input P.045 Application Setup (V/Hz
and Vector)
⇒
Fault
Functions
OUTPUT REG 1
SOURCE* Network Output
Register 1 Source Input P.066 Option Port
Configuration
⇒
Network
Configuration
OUTPUT REG 2
SOURCE* Network Output
Register 2 Source Input P.067 Option Port
Configuration
⇒
Network
Configuration
OUTPUT REG 3
SOURCE* Network Output
Register 3 Source Input P.068 Option Port
Configuration
⇒
Network
Configuration
OUTPUT REG 4
SOURCE* Network Output
Register 4 Source Input P.069 Option Port
Configuration
⇒
Network
Configuration
OUTPUT RELAY
CONFIG Output Relay
Configuration Input P.013 Regulator Terminal Strip
OVERFREQUENCY
LIMIT Overfrequency Limit Input H.022 Application Setup
(V/Hz)
P/M OUTPUT AMPS Power Module Output
Amps Read only P.095 Drive Status
PRESET SPEED 1 Preset Speed 1 Input P.031 Regulator Terminal Strip
⇒
Preset Speed Setup
PRESET SPEED 2 Preset Speed 2 Input P.032 Regulator Terminal Strip
⇒
Preset Speed Setup
PRESET SPEED 3 Preset Speed 3 Input P.033 Regulator Terminal Strip
⇒
Preset Speed Setup
PRESET SPEED 4 Preset Speed 4 Input P.034 Regulator Terminal Strip
⇒
Preset Speed Setup
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path