Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 97)

B-10 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
• MOTOR OVERLOAD TYPE SEL (P.041)
• FLT AUTO RESET COUNTS (P.043)
• FLT AUTO RESET TIME (P.044)
• FUNCT LOSS RESPONSE (P.026)
• OUTPUT PHASE LOSS EN (P.045)
• STOP/RST KEY DISABLE (P.055)
• AUTO/MAN KEY DISABLE (P.052)
• MAN REF PRESET ENABLE (P.053)
B.2.4 Performance Tuning (V/Hz)
• SLIP COMPENSATION (H.004)
• SYNC DIRECTION (H.016)
• IDENTIFICATION RESULT (H.019)
• Identification
B.2.5 Motor Data (V/Hz)
• MOTOR NAMEPL BASE FRQ (H.001)
• MOTOR NAMEPL AMPS (H.002)
• MOTOR NAMEPL VOLTS (H.000)
B.2.6 Drive Status
• ELAPSED TIME METER (P.029)
• ELPSD TIME METER RST (P.030)
• DIAGNOSTICS SELECT (P.090)
• DIAGNOSTICS DISPLY (P.091)
• P/M OUTPUT AMPS (P.095)
• SOFTWARE VERSION NUM (P.098)
B.2.7 Regulator Terminal Strip
• TS ANALOG IN OFFSET (P.009)
• TS ANALOG IN GAIN (P.010)
• TS ANALOG IN CONFIG (P.011)
• TS ANALOG OUT SOURCE (P.012)
• OUTPUT RELAY CONFIG (P.013)
• TS DIG INP CONFIG (P.007)
• TS SPEED REF SEL (P.008)