Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 15)

Description of the OIM Keypad, Display, and Indicators 2-3
Program Move the cursor between menu items or between the parameters and options in
the menus.
After you select a parameter to change, these keys increase or decrease the
digit at the cursor, or move between items in a list. Hold down one of these keys
to change values more quickly. See chapter 4 for more information on changing
values.
In help screens and fault messages, these keys move to more text if it is
available.
Monitor Increase or decrease the manual reference. See section 6.1.4 for information on
changing the reference
Program or
Monitor
In menus and the monitor mode screen, accesses the Language Selection
screen. See section 3.4 for more information on selecting a language.
In menus and the monitor mode screen, accesses the Contrast Adjustment
screen. See section 3.3 for more information on adjusting the contrast of the
display.
In parameter entry screens, and move the cursor left or right.
Table 2.1 – Programming Key Descriptions (Continued)
Key Mode Function
Table 2.2 – Control Key Descriptions
Key Mode Function
Program or
Monitor Allows you to select from a list of possible sources for the drive control signals.
is not active when the drive is running or jogging and during quick
start and self-tuning. See section 6.2 for more information on selecting a
control source.
Program or
Monitor Determines which reference the drive uses. See section 6.1.4 for more
information on selecting the reference. Refer to the P.052 (AUTO/MAN Key
Disable) and P.053 (Manual Reference Preset Enable) parameter descriptions
in the software I/M for more information about the AUTO/MAN key.
This key is not active if the control source is set to LOCAL.
Program or
Monitor Toggles direction of motor rotation when the control source is set to OIM. The
direction can be changed at any time.
Note that if the reference is zero, pressing this key will not alter the state of the
key indicator.
Refer to the P.027 (Forward/Reverse Configuration) parameter description in the
software I/M for more information.
!
ATTENTION: When switching from AUTO to MANUAL or from
MANUAL to AUTO, the drive will ramp to the reference level
provided by the new source at the rate specified in ACCEL TIME
(P.001), DECEL TIME (P.002), ACCEL TIME - SECONDARY
(P.017), or DECEL TIME - SECONDARY (P.018). Be aware that
an abrupt speed change might occur depending on the new
reference level and the rate specified in these parameters. Failure
to observe this precaution could result in bodily injury.