Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 81)

A-12 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
*Only supported for GV3000/SE Regulator board versions 6.0 and later.
TORQUE REG INT
GAIN Torque Regulator
Integral Gain Input U.015 Performance Tuning
(Vector)
⇒
Torque Loop
Tuning
TORQUE REG PROP
GAIN Torque Regulator
Proportional Gain Input U.014 Performance Tuning
(Vector)
⇒
Torque Loop
Tuning
TORQUE SELF-TUNE
EN Torque Self-Tune Enable Input U.008 Quick Start (Vector)
Performance Tuning
(Vector)
⇒
Self Tuning
Parameters
TORQUE SELF-TUNE
RSLT Torque Self-Tune Result Read only U.009 Performance Tuning
(Vector)
⇒
Self Tuning
Parameters
TRIM GAIN PERCENT Trim Gain Percentage Input P.015 Speed Control
⇒
Draw
& Trim Configure
TRIM REF SOURCE Trim Reference Source Input P.014 Speed Control
⇒
Draw
& Trim Configure
TS ANALOG IN
CONFIG Terminal Strip Analog
Input Configure Input P.011 Regulator Terminal Strip
TS ANALOG IN GAIN Terminal Strip Analog
Input Gain
Input P.010 Regulator Terminal Strip
TS ANALOG IN
OFFSET Terminal Strip Analog
Input Offset Input P.009 Regulator Terminal Strip
TS ANALOG OUT
SOURCE Terminal Strip Analog
Output Source Input P.012 Regulator Terminal Strip
TS DIG INPUT CONFIG Terminal Strip Digital
Inputs Configure Input P.007 Regulator Terminal Strip
TS SPEED REF SEL Terminal Strip Speed
Reference Source Input P.008 Regulator Terminal Strip
VHZ-CURVE TYPE Volts/Hertz Curve Type Input H.018 Application Setup
(V/Hz)
ZERO SPEED HOLD
TIME* Zero Speed Hold Time Input U.025 Application Setup
(Vector)
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path