Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 69)

7-10 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
GROUND FAULT FAILURE EC Earth current failure (ground
fault)
HIGH DC BUS VOLTAGE HU High DC bus voltage
HIGH LINE VOLTAGE HIL High line voltage (Prior to
Version 5.1, V/Hz only)
HIGH TIME
IDENTIFICATOIN
ABORTED HId High time identification aborted
IDENT REQUEST NOT YET
PERFORMED nId Identification Request not yet
performed (V/Hz only)
INPUT PHASE LOSS IPL Input phase loss
LOW DC BUS VOLTAGE LU Low DC bus voltage
MISSING POWER
MODULE ID CONNECTOR PUc Missing Power Module ID
connector
MOTOR OVERLOAD OL Motor overload
MOTOR PHASE LOSS PH Motor phase loss
NETWORK COMM LOSS nCL Network comm loss
NVRAM WRITE FAILURE EEr NVRAM write failure
OUTPUT PHASE LOSS OPL Motor output phase loss
OVERCURRENT
(AT ACCELERATION) OCA Overcurrent (at acceleration)
OVERCURRENT (AT DC
BRAKING) OCb Overcurrent (at DC braking)
OVERCURRENT
(AT DECELERATION) OCd Overcurrent (at deceleration)
OVERCURRENT (STEADY
STATE) OC Overcurrent (steady state)
OVERFREQUENCY OF Overfrequency
OVERSPEED OSP Overspeed (vector only)
POWER MODULE NOT
IDENTIFIED PUn Power Module not identified after
default restore
SELF-TUNING STATUS SF Self-tuning status (vector only)
SPURIOUS HOST PC
COMM INT UAr Spurious Host PC comm
interrupt
1 Only supported with GV3000/SE drive versions 6.0 and later.
Table 7.4 – List of Fault Codes Cross-Referenced to Front Panel Keypad/Display Fault Codes (Continued)
OIM Fault Name
Front Panel
Keypad/Display
Code
Software I/M
Fault Description