Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 72)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-3
ENCODER LOSS
ENABLE Encoder Loss Enable Input P.039 Application Setup
(Vector)
⇒
Fault
Functions
ENCODER PPR Encoder PPR Input U.001 Quick Start (Vector)
Application Setup
(Vector)
FLD-WEAKEN START
RPM Field Weakening Start
RPM Input U.016 Application Setup
(Vector)
FLT AUTO RESET
COUNTS Fault Auto Reset
Attempts Input P.043 Application Setup
(V/Hz and Vector)
⇒
Fault Functions
FLT AUTO RESET TIME Fault Auto Reset Time Input P.044 Application Setup
(V/Hz and Vector)
⇒
Fault Functions
FLX REG INT GAIN Flux Current Regulator
Integral Gain Input U.020 Performance Tuning
(Vector)
⇒
Torque Loop Tuning
FLX REG PROP GAIN Flux Current Regulator
Proportional Gain Input U.019 Performance Tuning
(Vector)
⇒
Torque Loop Tuning
FORWARD/REV
CONFIGURE Forward/Reverse
Configuration Input P.027 Speed Control
FRONT PNL SPD
SCALING Speed Display Scaling Input P.028 Speed Control
FUNCT LOSS
RESPONSE Function Loss
Response Input P.026 Application Setup
(V/Hz and Vector)
⇒
Fault Functions
HIGH BUS FLT AVOID
EN* High DC Bus Fault
Avoidance Enable Input U.024 Application Setup
(Vector)
⇒
Fault
Functions
IDENTIFICATION
RESULT Identification Result Read only H.019 Performance Tuning
(V/Hz)
IDENTIFICATION RQST Identification Request Input H.020 Performance Tuning
(V/Hz)
INERTIA COMP GAIN* Inertia Compensation
Gain Input U.027 Performance Tuning
(Vector)
⇒
Speed Loop
Tuning
INPUT PWR/SNUB
CONFIG Input Power/Snubber
Configuration Input H.017 Application Setup
(V/Hz)
JOG RAMP ACCEL
TIME Jog Ramp Accel Time Input P.021 Speed Control
⇒
Jog
Configure
JOG RAMP DECEL
TIME Jog Ramp Decel Time Input P.022 Speed Control
⇒
Jog Configure
JOG SPEED
REFERENCE Jog Speed Reference Input P.020 Speed Control
⇒
Jog Configure
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path