Great Plains DICKEY-john AI-120 12-inch Virtual Terminal - Manual (Page 137)

OPERATOR’S MANUAL
AI-120 Virtual Terminal
11001-1606B-201310
AS APPLIED JOB SETUP / 129
BOUNDARY OFFSET
Boundary offset draws a boundary line at a specific distance on the left or
right of the vehicle.
– For example, driving with vehicle center directly over the field
boundary, the offset would be zero.
Boundary offset is ideal for situations that require driving next to a field
boundary due to a fenceline. Offset values are positive or negative based
on the direction of travel in the field.
Figure 188
Negative and Positive Offset
Creating a Boundary Offset:
1. Select the Field menu button.
2. Press the Boundary Offset button. The boundary offset default is set
to 0.
3. Enter a value for the desired boundary offset using the virtual keypad
and press the Check button to accept.
4. The blue arrows have moved to the right most edge of the implement.
This is due to the boundary offset default set at +190 inches with the
implement having a length of 380. The left most edge of the implement
would require a boundary offset of -190 inches.
IMPORTANT: Changing a boundary offset while a boundary recording
is active will have no effect. The new boundary only
takes effect after a boundary recording is stopped or
paused and a recording is restarted.
Figure 189
Enter an Offset Value