Operator’s manual, Implement geometry – Great Plains DICKEY-john AI-120 12-inch Virtual Terminal User Manual
Page 75
OPERATOR’S MANUAL
AI-120 Virtual Terminal
11001-1606B-201310
TERMINAL SETUP / 67
LOAD AN EXISTING IMPLEMENT PROFILE
An existing implement and its configurations can be recalled.
1. At the Setup Menu screen, press the Implement/Select icons.
2. Select the desired implement in the upper window.
3. Press the Check button to accept.
4. Selecting a different implement requires a restart of the system.
System will automatically restart and will require acceptance of the
warning notification.
Figure 100
Select Existing Implement
IMPLEMENT GEOMETRY
Physical layout of the implement is required to determine the position of the
planter control channel in the field. Configuring an implement identifies the
type of implement attached, how much area the implement covers, and any
implement offset.
IMPORTANT: It is critical to enter the exact distances required when
setting up the physical layout of the implement position.
Do not guess; use a tape measure to find exact
measurements. Failure to enter accurate measurements
of the implement control channels will impact the
system’s performance.
NOTE:
Implement geometry will vary
based on the implement type
selected.
Typical implement dimensions include:
– (A) Swath width automatically populates with the implement width
dimension value from the IntelliAg Row Configuration screen.
– (B) Overlap
– (C) Implement offset is the distance from center of tractor hitch to
center of implement side-to-side.
– (D) Inline offset