Using the terminal, Operator’s manual, Console power on/off – Great Plains DICKEY-john AI-120 12-inch Virtual Terminal User Manual
Page 17
OPERATOR’S MANUAL
AI-120 Virtual Terminal
11001-1606B-201310
USING THE TERMINAL / 9
USING THE TERMINAL
CONSOLE POWER ON/OFF
In normal operation, the console turns ON when the ignition key is turned
ON.
NOTE:
The console may remain
powered for several minutes
when disconnected from a
power source because of an
internal battery.
1. Press and hold the Power button (green) for approximately 4 seconds
to turn the console ON or turn ignition key ON. Perform the same
procedure to turn the console OFF.
– A Reset button (red) allows a system reset if the console locks or
cannot be turned on and off normally using the Power button and
should only be used in this instance. Press and hold the Reset
button for approximately 3 seconds to begin reboot. A reset during
normal operations may cause active files not to save and lead to
potential data loss.
Figure 4
Console Power On and Off and Reset Button
2. Startup screens display while the system is booting.
3. A disclaimer screen appears that must be acknowledged before
proceeding. Use the up and down arrows to scroll between the two
pages to read. Both pages must be viewed before the Yes button is
enabled.
4. Press the Language button to view and change the language setting,
if desired. The default language is English.
5. Press the Yes button to accept.
IMPORTANT: By selecting YES at the Disclaimer screen, you are
confirming that you have read the disclaimer and agree
to take responsibility for any liabilities that may incur as
a result of failing to follow the instructions and
information as outlined in the disclaimer.