Operator’s manual, Task controller setup – Great Plains DICKEY-john AI-120 12-inch Virtual Terminal User Manual
Page 152
OPERATOR’S MANUAL
AI-120 Virtual Terminal
11001-1606B-201310
144 / VARIABLE RATE JOB SETUP
Figure 208
Editing Task Data Files
TASK CONTROLLER SETUP
A variable rate task loaded to the terminal must be selected after a
successful import.
1. Press the Task Data Menu button.
2. Press the Configure Variable Rate Control button.
3. At the ISO Task Controller Setup screen, select the Control Target for
the first task data source.
4. Select the Target Element titled IntelliAg to open the device element
choices.
5. Select the appropriate device element.
6. Press the Check button to accept.
7. Follow the same steps 3-7 to assign a control target for the next task
data source, if required.
8. Press the Check button to finalize control targets.
9. A Begin Task Conversion window displays indicating the prescription
map is ready to load. Press the Check button to accept.
Each row in the table represents a variable or fixed prescription for a control
target on the implement. The names and number of control targets that are
selectable depends on the ISOBUS implement.