Bio-Rad BioFrac™ Fraction Collector - Manual (Page 68)

5 | Stand-Alone Operation
60 | BioFrac Fraction Collector
The fraction collector stops when the last tube is reached unless a stop
command is received before it reaches the last tube. At the end of a run, the
start tube number and end tube number will be automatically updated
according to the MultiRun mode selected.
5. Set the fraction size units (min, ml, or drops) and enter the fraction size. If
collecting by volume, you must enter a flow rate.
6. (Optional) Press Collect (F4) and set the delay time (see Collect Using a Delay
Function on page 67 ).
7. (Optional) Press Methods (F3) and save your method.
8. Press Run (F1) to start the experiment.
At any point during the run you can use the Run screen function keys (see
Table 8 on page 43 ).