Dell PowerVault MD3000 - Manual (Page 131)

Script Commands
131
[capacity= virtualDiskCapacity owner=(0 | 1)
segmentSize= segmentSizeValue
enclosureLossProtect=(TRUE | FALSE)]
Parameters
Parameter Description
physicalDisks Specifies the physical disks to assign to the created
virtual disk. Specify the enclosure ID and slot ID for
each unassigned physical disk to assign to the virtual
disk. Enclosure ID values are 0 to 99. Slot ID values are
0 to 31. You must put parentheses around the enclosure
ID values and the slot ID values.
raidLevel RAID level of the disk group that contains the virtual
disk. Valid values are 0, 1, 5, or 6.
NOTE:
If you set the raidLevel parameter to RAID 1, the
RAID controller module firmware takes the list of physical
disks and pairs them using the following algorithm:
Data physical disk = X
Consistency physical disk =
where X goes from 1 to
and N is the number of
physical disks in the list. The following data show an
example of six physical disks and their mirror pairs.
Data Consistency
1
2
3
userLabel Name that you want to give the new virtual disk. You
must put quotation marks (" ") around the new virtual
disk name.
NOTE:
You can use any combination of alphanumeric
characters, hyphens, and underscores for the names.
Spaces are not allowed. Command names can have a
maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle
brackets (< >) to overcome this limitation.
N 2
⁄
X +
N 2
⁄
N 2
⁄
1 4 = +
N 2
⁄
1 5 = +
N 2
⁄
1 6 = +