Dell PowerVault MD3000 - Manual (Page 187)

Script Commands
187
IPv6NdDetectDuplicateAddress=[0-256] |
IPv6NdReachableTime=[0-65535] |
IPv6NdRetransmitTime=[0-65535] |
IPv6NdTimeOut=[0-65535] |
IPv4Priority=[0-7] |
IPv6Priority=[0-7] |
IPv4SubnetMask=(0-255).(0-255).(0-255).(0-255) |
IPv4VlanId=[1-4094] |
IPv6VlanId=[1-4094] |
maxFramePayload=[ frameSize ] |
tcpListeningPort=[3260, 49152-65536] |
Additional Information
When you use this command, you can specify one or more of the parameters.
You do not need to use all of the parameters. Setting the availability
parameter to serviceMode causes the alternate RAID controller module to
take ownership of all of the virtual disks. The specified RAID controller
module no longer has any virtual disks and refuses to take ownership of any
more virtual disks. Service mode is persistent across reset cycles and power
cycles until the availability parameter is set to online.
Use the show controller NVSRAM command to show the NVSRAM
information. The maxFramePayload option is shared between IPv4 and IPv6.
The payload portion of a standard Ethernet frame is set at 1500, and a jumbo
Ethernet frame is set at 9000. When using jumbo frames, all of the devices
that are in the network path should be capable of handling the larger frame
size.
You must set the enableIPv4 parameter or the enableIPv6 parameter to TRUE
to make sure that the specific IPv4 setting or the specific IPv6 setting is
applied.
When the duplexMode parameter is set to TRUE, the selected Ethernet port
is set to full duplex. The default value is half duplex (the duplexMode
parameter is set to FALSE).