Dell PowerVault MD3000 - Manual (Page 189)

Script Commands
189
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
Set Snapshot Virtual Disk
This command defines the properties for a snapshot virtual disk and enables
you to rename a snapshot virtual disk.
Syntax
set (virtualDisk [ virtualDiskName ] |
virtualDisks [ virtualDiskName1 ...
virtualDiskNamen ]) userLabel=
password Specifies the password for the storage array. You
must put quotation marks (" ") around the password.
NOTE:
Passwords are stored on each storage array in
a management domain. If a password was not
previously set, you do not need a password. The
password can be any combination of alphanumeric
characters with a maximum of 30 characters. (You can
define a storage array password by using the set
storageArray command.)
performanceMonitorInterval Specifies how frequently to gather performance
data. Enter an integer value for the polling interval,
in seconds, for which you want to capture data. The
range of values is 3 to 3600 seconds. The default
value is 5 seconds.
NOTE:
The polling interval you specify remains in
effect until you end the session. After you end the
session, the polling interval returns to the default
values.
performanceMonitorIterations Specifies the number of samples to capture. Enter
an integer value. The range of values for samples
captured is 1 to 3600. The default value is 1.
NOTE:
The number of iterations you specify remains
in effect until you end the session. After you end the
session, the number of iterations returns to the default
values.
Parameter Description