Dell PowerVault MD3000 - Manual (Page 158)

158
Script Commands
NOTE:
If the warningThresholdPercent parameter or the repositoryFullPolicy
parameter is not specified, the previously set values are used. If you use the
optional parameters, the re-create Snapshot will process each snapshot virtual
disk separately. If the same userLabel (name) is specified for more than one virtual
disk, the command fails. If no optional parameters are specified, the re-create
Snapshot will process the specified snapshot virtual disks as a batch, provided a
validation check of all of the virtual disks runs successfully. If successful, the
snapshots start the re-creation process and all of the affected virtual disks
(snapshot, source, and repository) are quiesced until the process is complete.
NOTE:
If no optional parameters are specified, the recreate snapshot command
will process the specified snapshot virtual disks as a batch, provided a validation
check of all of the virtual disks runs successfully. If successful, the snapshots start
the re-creation process and all of the affected virtual disks (snapshot, source, and
repository) are quiesced until the process is complete.
NOTE:
The Microsoft Virtual Shadow Copy Service (VSS) provider allows the
recreation of multiple snapshots simultaneously.
Remove Virtual Disk Copy
This command removes a virtual disk copy pair.
Syntax
remove virtualDiskCopy target [ targetName ] [source
[ sourceName ]]
Parameters
Parameter Description
target Name of the target virtual disk to remove. You must put
brackets ([ ]) around the target virtual disk name. If the target
virtual disk name has special characters, you must also put
quotation marks (" ") around the target virtual disk name.
source Name of the source virtual disk to remove. You must put
brackets ([ ]) around the source virtual disk name. If the
source virtual disk name has special characters, you must also
put quotation marks (" ") around the source virtual disk name.