Dell PowerVault MD3000 - Manual (Page 166)

166
Script Commands
Parameters
Save Storage Array Configuration
This command creates a script file to use to create the current storage array
virtual disk configuration.
Syntax
save storageArray configuration file=" filename "
[(allConfig | globalSettings=(TRUE | FALSE)
virtualDiskConfigAndSettings=(TRUE | FALSE)
hostTopology=(TRUE | FALSE)
lunMappings=(TRUE | FALSE))]
Parameters
Parameter Description
controller RAID controller module with the NVSRAM values to save.
Valid RAID controller module identifiers are 0 or 1, where 0
is the RAID controller module on the left and 1 is the RAID
controller module on the right when viewed from the rear of
the enclosure. You must put brackets ([ ]) around the RAID
controller module identifier.
file Name of the file in which to save the values. You must put
quotation marks (" ") around the file name.
Parameter Description
file Name of the file that contains the configuration values.
You must put quotation marks (" ") around the file
name.
allConfig Saves all of the configuration values to the file. (If you
choose this parameter, all of the configuration
parameters are set to TRUE.)
globalSettings Saves the global settings to the file. To save the global
settings, set this parameter to TRUE. To prevent saving
the global settings, set this parameter to FALSE. The
default value is TRUE.