Dell PowerVault MD3000 - Manual (Page 136)

136
Script Commands
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
NOTE:
One technique for naming the snapshot virtual disk and the repository
virtual disk is to add a hyphenated suffix to the original name of the source virtual
disk. The suffix distinguishes between the snapshot virtual disk and the repository
virtual disk. For example, if you have a source virtual disk with a name of
Engineering Data, the snapshot virtual disk can have a name of Engineering Data-
S1, and the repository virtual disk can have a name of Engineering Data-R1.
repositoryPercentOfSource The size of the repository virtual disk as a
percentage of the source virtual disk. Use
integer values. For example, a value of 40
means 40 percent. The default value is 20.
repositoryUserLabel The name to give to the repository virtual
disk. You must put quotation marks (" ")
around the repository virtual disk name.
repositoryFullPolicy Specifies how snapshot processing
continues if the repository is full. You can
choose to fail writes to the source virtual
disk (failSourceWrites) or fail the
snapshot virtual disk (failSnapShot). The
default value is failSnapShot.
enclosureLossProtect Specifies that enclosure loss protection is
enforced when creating the repository. To
enforce enclosure loss protection, set this
parameter to TRUE. The default setting
is FALSE. For information about the
enclosureLossProtect parameter, see
"Enclosure Loss Protection" on page 52.
Parameter Description