Dell PowerVault MD3000 - Manual (Page 226)

226
Script Commands
NOTE:
Use the save physicalDiskChannel faultDiagnostics command and the stop
physicalDiskChannel faultDiagnostics command in association with the start
physicalDiskChannel faultDiagnostics command. These commands are needed to
save the diagnostic test results to a file and to stop the diagnostic test.
NOTE:
You can stop this command at any time by pressing Ctrl+C.
Start Physical Disk Blink
This command identifies a physical disk by turning on the indicator LED on
the physical disk. (Use the stop physicalDisk blink command to turn off the
indicator LED on the physical disk.)
Syntax
start physicalDisk [ enclosureID,slotID ] blink
Parameters
Start Physical Disk Initialize
This command starts physical disk initialization.
NOTICE:
As soon as you enter this command, all user data is destroyed.
Syntax
start physicalDisk [ enclosureID,slotID ] initialize
Parameters
Parameter Description
physicalDisk Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.
Parameter Description
physicalDisk Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.