Dell PowerVault MD3000 - Manual (Page 204)

204
Script Commands
Syntax
show iscsiInitiator iscsiSessions
[ iscsiInitiatorName | iscsiTargetName ]
Parameters
NOTE:
If you enter this command without defining any arguments, this command
returns information about all iSCSI sessions that are currently running. To limit the
information returned, enter a specific iSCSI initiator or a specific iSCSI target. This
command then returns information about the session for only the iSCSI initiator or
the iSCSI target that you named.
Show Disk Group
This command returns the following information about a disk group:
• Status (online or offline)
• Physical disk type (SAS or SATA)
• Enclosure loss protection (yes or no)
• Current owner (RAID controller module 0 or RAID controller module 1)
• Associated virtual disks and free capacity
• Associated physical disks
NOTE:
You can use the free capacity area value when you create a virtual disk
based on the free capacity of a disk group. For a description of how to use the free
capacity value, see the create virtualDisk command on "Create RAID Virtual Disk
(Free Capacity Base Select)" on page 128.
Syntax
show diskGroup [ diskGroupNumber ]
Parameter Description
iscsiInitiatorName The name of the iSCSI initiator for which you want to
obtain session information.
Enclose the
iSCSI initiator
name in square brackets ([ ]).
iscsiTargetName The name of the iSCSI target for which you want to obtain
session information.
Enclose the
iSCSI target
name in
square brackets ([ ]).