AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 103)

97
snapshot the channel video.
 Camera #: the selected channel would be snapshot when an alarm is occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.
d. Snapshot Interval: a time gap for next snapshot
e. Save Path: a storage path for saving snapshot pictures.
f. Delete image after: Set a snapshot images storage limit on hard disk. When the snapshot
images storage limit has reached, the DVR system will delete the snapshot images from hard
disk.
4.9.1 To Setup Alarm Relay:
1. Next to the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list and in the ON column, set to
enable/disable the relay operation when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable to extend the relay operation time and set the
duration in second.
4. Click OK to exit and accept the setting and Cancel to exit without saving the setting.