AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 129)

123
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the recording
mode and click the  button. If you want to only record at a particular time, click the Schedule button and
click colored block, then click on the time blocks in Recording Mode window. When the system starts
recording a red triangle mark would appear at the upper left corner of the screen.
The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once a
motion is detected, the system automatically saves the previous frames and stop based on the Start
Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected and if
there is no motion, it records at the minimum frame rate setting.
- No Recording
The system won’t do any recording.
- KeyFrame Recording
Only record one frame per second.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected. When
it detects a motion, a green triangle mark would appear at the upper left corner of the screen.