AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 70)

64
3. The system automatically detects the camera and input relates information. In the
Content section, enter sensor description.
4. In the test section, click Test to check the sensor status. Red is high and Green is low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
 Relay Setting: To setup relay device that is embedded on the camera.
1. Click the drop-down list and select the relay ID number.
2. Enter relay name in Name column
3. The DVR system automatically detects the camera and input relates information. In the
Content section, enter relay description.
4. In the test section, click Test to trigger relay. Red is high and Green is low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.