AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 107)

101
2. In Local Phone Number text box, enter the GSM SIM card phone number.
3. In Phone Num text box, enter the contact number.
4. You may now set to send thru SMS &/or MMS. If you enable SMS setting, just enter the message in the
text box. If you enable MMS, enter the APN name, WAP IP, MMS address and the message. If you are
not sure, please contact your mobile service provider.
5. Attach image when sensor is triggered select the camera that the images will be capture and send
when the sensor is triggered.
6. Click OK to accept the new settings and Cancel to exit without saving.
i
- Make sure your ISP provider and cell phone provider both support JPG file format transmitting.
- RS232 port can’t be connected to SMS/MMS modem, you need to use USB to RS232 converter
to connect
4.9.7 To Setup PTZ Preset Point:
Next to the PTZ preset point check box, click Detail. In the Trigger PTZ Preset Setting dialog box, select the
PTZ camera number then select the Enable check box. Select the position of the PTZ camera when the
alarm is activated and ended. For the PTZ camera ended point, user also can select one preset position or
Auto Pan between preset position groups.
4.9.8 To Setup Alarm SOP:
Next to the Alarm SOP check box, click Detail. In the step text boxes, type the standard protocol when the
alarm is activated. When the alarm is activated the Standard Operation Procedure dialog box will appear.
Just click Next to see the next instruction, Back to see the previous instruction, Finish to end and Abort to
terminate.