AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 50)

44
- Status Report
Send a daily system event and attention analysis report. To change the e-mail settings, click Setup.
- Beep if no signal
Make sound when the video signal is lost.
- Mandatory Record
Always record video when software is running.
- Enable Overlay
To enhance video signal for better video quality.
- Enable Liveplayback
To allow instantly live playback while recording in preview mode (see also (19)Live playback in Chapter
3.2).
- Screen Saver
Set a period time to enter screen saver mode when system idle.
- Auto Scan Period
Set the time gap of the Auto Scan function from 3 to 10 seconds. This automatically switches to the next
video in cycle depending on the set time gap.
- Temperature Display
Select the format of temperature -- °C or °F
- Playback Mode
Select the mode of playback the video.
 Select date and time: Select the date and time which user wants to playback.
 Play the last file: Automatically playback the video from the last hour
 Instant Playback: Automatically playback the video which has just recorded. To set the instant
playback time period, fill in the time in second at
Set Instant Playback’s Play Time column.
- Date Format
Select the date format which wants to display in Select date and time playback mode
(10) Dual Monitor
Mark to enable the Playback UI to display on 2
nd
monitor. In default, DVR system only display on one monitor
but the dual output is enabled.
i To disable the dual monitor function when only has connected one monitor. Otherwise, the Playback
UI won’t be able to display on main monitor screen.
(11) POS
Set from which camera screen to display the data from the POS equipment. Click Setting, to set the POS
Console Setting. (see also Chapter 4.1.1)
(12) UPS (Uninterruptible Power Supply)
Protect the system from damaging, such as power surges or brownouts. This automatically gives time to
close the DVR system properly when the battery backup power has reached the Shutdown when capacity
below percentage level setting. The UPS device must be connected to your computer..