AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 85)

79
When the system starts recording a red triangle mark would appear at the upper left corner of the screen.
The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path (see also
Chapter 4.1 #1).
- Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once a
motion is detected, the system automatically saves the previous frames and stop based on the Start
Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected and if
there is no motion, it records at the minimum frame rate setting.
- Voice Detecting Recording
DVR system will record the sound when the voice exceeds the intensity value in Voice Detection setting.
- No Recording
The system won’t do any recording.
- KeyFrame Recording
Only record one frame per second.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected. When it
detects a motion, a green triangle mark would appear at the upper left corner of the screen. Click Advanced
button to select the area for motion detection. Click Region 1/2/3 button, and then, click-and-drag an area on
camera screen for motion detect. To adjust motion detect sensitive, scroll the Sensitivity 1/2/3 bar. Click OK
to save and exit the setting window. To reset all setting, click Default.
(4) Mask/Shield Edit
Mask, mark an area on the screen to disregards the motion in the marked area and to only monitor outside
the marked area. Select the color of mask and click and drag a frame on the video screen to create Mask
area. Enable the Show Mask check box to show the mask frame on surveillance screen.
Click Region button to
select the motion detect
area.