AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 17)

11
2.1.2 IWH3216 Touch II
The DVR unit can support up to 4 SATA hard disks. Follow the illustrated instructions below to install the hard disk:
1. Push the lock to open the HDD drawer.
2. And then, pull out the HDD drawer from DVR unit.
3. Open the HDD drawer case cover and takes out the
accessories kit (key & screws).
4. And then, place the SATA hard disk inside the HDD
drawer.
5. Turn the plate and hard disk over carefully and
secure the hard disk inside the HDD drawer. Use the
screw has flat head.
6. After screwed hard disk, turn the HDD drawer over
and close the case cover.
7. Slide the HDD drawer back to the DVR unit.
8. Lock the HDD drawer by using the key that is
included in accessories kit.
9. User may now connect all the cables and power on the DVR unit.
The hard disk ’s connect interface should be
placed in this side of HDD drawer.