AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 94)

88
4.7 Sensor Setting
The I/O device must be installed to use this function.
1. Click the drop-down list and select the sensor ID number.
2. Give a name to the sensor in Name column.
3. Click External IO to configure external I/O device if it is available(see also Chapter 4.7.1)
4. The system automatically detects the sensor and input relates information. User can enter a short
description for this relay in Description frame.
5. In the test section, click Test to check the sensor status. Red is high and Green is low.
6. Click OK to exit and accept the setting and Cancel to exit without saving the setting.