Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 155)

SpHb frame
The SpHb frame displays data and controls used in total hemoglobin measurements.
Note SpHb is available only in the Intervals Monitoring and Continuous
Monitoring profiles.
In this frame, one of two labels appears:
•
SpHbv indicates the venous calibrated reference for total hemoglobin measurement.
• SpHb indicates the arterial calibrated reference for total hemoglobin measurement.
You can specify the reference source in Advanced settings.
The frame provides a numeric view and a graphical trend view of total hemoglobin data.
You can toggle between views by touching the left side of the frame.
SpHb numeric view
The numeric view indicates the total hemoglobin level in either grams per deciliter (g/dL)
or millimoles per liter (mmol/L). You can select the unit of measure in Advanced settings.
The size of the SpHb frame and displayed measurements varies based on your
configuration.
Averaging
The averaging button enables you to select the moving window of time used by the
parameter to calculate the SpHb value and update the display: short (approximately 1
minute), medium (approximately 3 minutes), or long (approximately 6 minutes).
SpHb graphical trend view
The graphical trend view presents a trend of the measurements over a user-selected
period. You can select the period displayed on the Setup tab. The size of the SpHb frame
and displayed trend varies based on your configuration.
The graph shows total hemoglobin level on the y-axis and time on the x-axis (oldest
measurements on the left to newest measurements on the right). The entire graph
updates every 10 seconds.
To the right of the graph, the frame displays the current measurement in numeric
format.
Set up SpHb
Follow these steps to configure SpHb parameter settings.
Directions for use Patient monitoring 149