Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 135)

Start automatic intervals
Follow these steps to configure the monitor to take NIBP measurements at consistent
intervals.
1. Properly size the blood pressure cuff and position it around the patient’s bare upper
arm.
2. On the Home tab, touch .
3. Select Automatic.
4. Use the numeric keypad to enter the length of time between NIBP measurements.
5. Touch Start intervals.
Note Intervals are not available in all profiles. See the Profiles
section for more information.
Program intervals
You can configure the monitor to take automatic NIBP measurements at variable
intervals. The monitor comes with preset interval programs that can be edited to meet
your needs. You can rename selected programs using the keyboard feature. The
columns below the selected program name indicate the length of each interval in the
cycle (Interval) and the number of intervals you set (Frequency).
Start program intervals
Follow these steps to configure the monitor to take automatic NIBP measurements at
variable intervals.
1. Properly size the blood pressure cuff and position it around the patient’s bare upper
arm.
2. On the Home tab, touch .
3. Select Program.
4. Touch the desired program.
5. Touch Start intervals.
Directions for use Patient monitoring 129