Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 31)

Mount the monitor on a stand
1. Align the monitor on the mounting bracket in the center of the stand tray. Slide the
monitor into place, catching the bracket in the guides on the bottom of the monitor.
2. Ensure that the monitor is properly seated on the bracket. If you can raise either side
of the monitor off the stand, it is not seated properly. Repeat step 1 until the monitor
is mounted correctly.
3. Tighten the screw on the bracket into the screw hole on the back of the monitor.
Mount the monitor on the wall
For mounting instructions, see the wall mount manufacturer's directions for use.
Attach the probe well
1. Align the probe well with the tabs facing up and down and insert the probe well into
the temperature module.
The probe well snaps into place when it is fully seated.
2. Insert the temperature probe into the probe well.
Directions for use Setup 25