Cisco 3825 - Manual (Page 327)

B-59
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix B Configuration Examples
Overview
UMTS Only Configuration without IMA
The traditional UMTS configuration is similar to the GSM configuration except only UMTS traffic
traverses the topology. Unlike GSM traffic, UMTS traffic arrives at the RAN-O device via ATM PVCs.
The UMTS traffic is then routed over the traditional MLPPP backhaul connection. At the RNC side, the
RAN-O to RNC connectivity is exactly like the Node-B to RAN-O interface connections. Aside from
the necessity of ATM connectivity, the physical connectivity for UMTS is exactly like the GSM topology
(see
Figure B-9 on page B-59 ).
Figure B-9 UMTS Only Configuration without IMA
MWR_A
!
card type E1 0 0
card type E1 0 1
!
!
redundancy
mode y-cable
standalone
!
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-participate aim 1
network-clock-select 1 E1 0/0/1
!
ipran-mib snmp-access inBand
ipran-mib location cellSite
!
!
controller E1 0/0/0
mode atm aim 1
clock source internal
!
controller E1 0/0/1
channel-group 0 timeslots 1-31
!
!
class-map match-any llq-class
match ip dscp ef
!
!
policy-map llq-policy
class llq-class
priority percent 99
class class-default
bandwidth remaining percent 1
queue-limit 45
!
Node-B
MWR_A
UMTS Only Configuration
No IMA
ATM0/0/0 Multilink1
10.10.10.1/30
Multilink1
10.10.10.2/30
ATM0/0/0
MWR_B
RNC
270642