Using the setup command facility, Configuring global parameters – Cisco 3825 User Manual
Page 54
3-4
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 3 First-Time Configuration
Configuring Global Parameters
Using the Setup Command Facility
The setup command facility is displayed in your PC terminal emulation program window.
To create a basic configuration for your router, do the following:
•
Complete the steps in the
“Configuring Global Parameters” section on page 3-4
•
Complete the steps in the
“Completing the Configuration” section on page 3-7
.
Note
If you make a mistake while using the setup command facility, you can exit the facility and run it again.
Press Ctrl-C, and type setup at the enable mode prompt (
1900#
).
Configuring Global Parameters
Step 1
Power on the router.
Messages will begin to appear in your terminal emulation program window.
Caution
Do not press any keys on the keyboard until the messages stop. Any keys that you press during this time
will be interpreted as the first command entered after the messages stop, which might cause the router
to power off and start over. Wait a few minutes. The messages will stop automatically.
The messages look similar to the following:
Note
The messages vary, depending on the Cisco IOS software image and interface modules in your
router. The screen displays in this section are for reference only and might not match the
messages on your console.
rommon 1 >boot
program load complete, entry point: 0x8000f000, size: 0xc0c0
Initializing ATA monitor library.......
program load complete, entry point: 0x80010000, size: 0x2888ab0
Self decompressing the image :
############################################################################
[OK]
Smart Init is enabled
smart init is sizing iomem
ID
MEMORY_REQ
TYPE
00042A
0X010D78F3 C3825 motherboard
0000D6
0X000D8A10 FE Port Module, 2 WAN
0000D6
0X000D8A10 FE Port Module, 2 WAN
0X00288860 Onboard PVDM2 SIMM
0X000021B8 OnboardUSB
000587
0X0030FEF2 ATM AIM-8 with SAR only, no DSPs
000587
0X0030FEF2 ATM AIM-8 with SAR only, no DSPs
0X00660670 public buffer pools
0X0078F000 public particle pools
TOTAL:
0X02922B7F