Toa D-901 KR - Manual (Page 18)

18
7. FLOW VIEW
The flow view displays a block diagram that shows the signal-processing image of D-901 using functional
boxes.
Matrix (See p. 19 .)
Compressor
(See
p. 23 .)
Delay
(See
p. 40 .)
Signal indicator * 1
High-pass filter/parametric equalizer (See p. 21 .)
Lock indicator * 2
Feedback suppression
function (See
p. 42 .)
Effect/Echo (See p. 41 .)
Trim (See p. 20 .)
Auto mixing function (See p. 27 .)
Signal indicator * 1
Compressor (See p. 23 ) / Auto-leveler (See p. 25 .)
: When the compressor mode is selected.
: When the auto-leveler mode is selected.
* 1 Indicates input/output signal levels as follows:
Lights red when a signal level is over 17 dB above the rated level.
Lights green when a signal level is between 40 dB below and 17 dB
above the rated level.
Lights gray when a signal level is over 40 dB below the rated level.
* 2 Lights red if the protect function is enabled.
Crossover (Xover) (See p. 36 .)
: Low-pass filter
: High-pass filter
: Band-pass filter
(High-pass filter + low-pass filter)
Multi-band filter (See p. 34 .)
Fader (See p. 32 .)
Auto mixing group (See p. 27 .)
Channel error status indicator
(See
p. 44 , 46 )
Lights red when an error
has occurred, which is valid
only when the D-923AE or
D-937SP is used.