Toa D-901 KR - Manual (Page 32)

32
8.6. Fader View (I/O Gain and I/O Group Trim Settings)
Clicking the Fader box causes the Fader View to appear.
8.6.1. I/O gain settings
The screen of the [Fader] tab is first displayed if you click the Fader box.
(3)
(4)
(5)
(2)
(1)
(1) Grouping button [Grouping]
Displays the channel group number assigned to each channel.
Press this button and select [Grouping
→ (Channel)] to perform the channel group setting.
If you move a fader of a grouped channel, the faders of other channels of the same group also move in
synchronization with the first operated fader.
The channel group setting makes the group trim gain (Gr. Trim) valid, allowing the offset gain of each
grouped channel to be set.
(2) Group trim gain button [Gr Trim]
Displays the group trim gain set for each channel by means of
numerical values.
When channel group settings have been performed, if you press
this button, a dialog for fader setting displayed, enabling you to set
the trim gain by directly entering a numerical value. The group trim
gain setting performed in this dialog corresponds directly to the
group trim gain setting shown on the [Gr Trim] tab screen.
Setting range: –
∞ (–80) to +10 dB
The Up and Down buttons located on the right side can also be
used to change the value in 0.1 dB units.
(3) Fader
Used to change the signal level of each channel.
(4) Gain indication button [Fader (dB)]
Displays the level for each channel by means of numerical values.
A dialog for fader setting is displayed if you press this button,
enabling you to perform the setting by directly entering a numerical
value.
Setting range: –
∞ (–70) to 0 dB
The Up and Down buttons located on the right side can also be
used to change the value in 0.1 dB units.
(5) Channel ON/OFF button [On/Off]
Displays the ON/OFF setting status of each channel. Press this button to turn on or off the channel.