Toa D-901 KR - Manual (Page 19)

19
8. CONTENTS VIEW
Clicking the box in the flow view causes the corresponding contents view to be displayed under the flow view.
8.1. Matrix View (Bus Assignment and Crosspoint Gain Setting)
The matrix view is displayed if you click the [Matrix] box.
Crosspoint being selected
• indicates input and output signal routings.
• A black, thicker frame indicates the crosspoint being selected.
• The crosspoint turns on and off as it is double-clicked.
(Displayed in numerical form)
(1) Fader
If you select the Crosspoint set to on, the corresponding Fader is displayed.
You can change the signal level at the selected Crosspoint by moving this fader up or down.
(2) Level setting button [Level (dB)]
If you select the Crosspoint set to on, the corresponding Level setting
button [Level (dB)] is displayed.
Indicates the signal level at the selected Crosspoint by means of
numerical values.
If you press this button, a dialog for level setting is displayed, enabling
you to set the level by directly entering a numerical value.
Setting Range: –
∞ (–70) to 0 dB
You can also change the level in 1 dB units with the UP and Down
buttons located on the right side.
(1)
(2)
(3)
(1)
(2)
(3)