Toa D-901 KR - Manual (Page 41)

41
8.10. Effect/Echo View (Effect/Echo Function Settings)
If you click the Effect (Echo) box, the Effect/Echo View is displayed.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(1) Gain indication button [Output Gain (dB)]
Displays the echo output gain. A dialog for gain setting is displayed if
you press this button, enabling you to set the gain by directly entering a
numerical value.
Setting range: –
∞ (–70) to 0 dB
The Up and Down buttons located on the right side can also be used to
change the value in 1 dB units.
(2) Ratio indication button [Feedback Ratio (%)]
Displays the feedback ratio. A dialog for ratio setting is displayed if you
press this button, enabling you to set the ratio by directly entering a
numerical value.
Setting range: 0 – 99%
The Up and Down buttons located on the right side can also be used to
change the value in 1% units.
(3) Feedback delay button [Feedback Delay (ms)]
Displays the feedback delay time. A feedback delay time setting dialog
is displayed if you press this button, enabling you to set the delay time
by directly entering a numerical value.
Setting range: 0 – 682 ms
The Up and Down buttons located on the right side can also be used to
change the value in 1 ms units.
(4) Pre-delay button [Pre-Delay (ms)]
Displays the pre-delay time. A pre-delay time setting dialog is displayed
if you press this button, enabling you to set the pre-delay time by
directly entering a numerical value.
Setting range: 0 – 682 ms
The Up and Down buttons located on the right side can also be used to
change the value in 1 ms units.
(5) Low-pass filter frequency button [LPF Freq. (Hz)]
Displays the low-pass filter's cut-off frequency. A dialog for cut-off
frequency setting is displayed if you press this button, enabling you to
set the frequency by directly entering a numerical value.
Setting range: 20 – 20,000 Hz
The Up and Down buttons located on the right side can also be used to
change the value.
(6) Q indication button [LPF Q]
Displays the low-pass filter's Q value. Pressing this button permits the setting value to be selected from the
pull-down menu.
The Up and Down buttons located on the right side can also be used to change the value.