Toa D-901 KR - Manual (Page 57)

57
• Press the "Complete" button after data transfer is completed.
• To terminate communications, select [Remote
→ Disconnect] from the menu.
• Select [Remote → Bulk transmission] from the menu when transmitting PC data to the D-901 without
displaying the confirmation screen of the memory contents of the PC and the connected D-901 unit.
Notes
· If the module configuration does not match, data cannot be transmitted even if "Bulk transmission" is
selected.
· The optional D-984VC VCA Control Module will not control the sound volume during bulk transmission.
Decrease the sound volume before bulk transmission.
• Select [Remote
→ Bulk receiving] from the menu to allow the PC to receive the D-901 data without
displaying the confirmation screen of the memory contents of the PC and the connected D-901 unit. The
memory selection number recalled after bulk reception is the same as the memory number set in the D-901
(The memory number being called by the D-901).
Note
The optional D-984VC VCA Control Module will not control the sound volume during bulk receiving.
Decrease the sound volume before bulk receiving.
• To display the D-901's firmware version number, select [Remote
→ Firmware] from the menu during
communications. Because a dialog for D-901 version information is displayed, check it and click the [OK]
button.