Doremi DSV-J2 - Manual (Page 21)

5 DSV-J2 IP Address
All DSV-J2 servers are shipped with a default IP address of 192.168.100.50 on the Ethernet
port (Eth1) and a DHCP assigned dynamic IP address on the Ethernet port (Eth0). See section
4.3 to locate each Ethernet connector.
To change the IP address of the DSV-J2 server, go to Menu → System → Networking Setup
and follow the steps below:
 From the DSV-J2 menu, select Menu → System → Networking Configuration and
you should be asked for a password (Figure 22):
Figure 22: Authentication Windows
 Then follow the steps starting with the following windows (Figure 23):
Figure 23: DSV-J2 Network Configuration
In the steps that follow, use the arrow down or the Tab key to select OK then hit <enter>:
1.) Enter the desired system’s hostname and select OK.
2.) Select OK for your system's domain name.
3.) Select Yes for eth0.
4.) Select No for Removable Device.
5.) Select No for automatically configure device with DHCP.
6.) Enter the desired IP address for eth0 and select OK.
7.) Enter the desired default gateway or leave empty and select OK.
8.) Enter the desired subnet mask and select OK.
DSV.OM.000391.DRM Page 21 of 68 Version 1.3
Doremi Labs