Doremi DSV-J2 - Manual (Page 43)

11 DSV-J2 Linux Terminal Commands
The DSV-J2 uses the Linux operating system. Here are some basic instructions on how to
navigate the Linux interface and access setup options to configure your system.
11.1 Linux Login & Terminal Window (Local Connection)
Connect a standard VGA monitor, keyboard, and mouse to the DSV-J2 and power up the unit.
Note: For more information on how to connect peripheral hardware, please see sections 3 and
4.
After the DSV-J2 boots up at power on, a login window comes up within the Linux GUI. To login,
type the following:
login: root <enter>
password: xxxxx <enter> // consult your system administrator for the root password or
Doremi to know the default root password.
This is the default login name and password for the DSV-J2. Use this login for basic setup
and configuration of the DSV-J2. To change the login password, see section 11.9. If the
password has already been changed, contact your system administrator for the new password.
Once you have logged in, you will see the Linux desktop. Next, open a terminal window. To do
this, click the terminal icon on the taskbar or select Menu → System → Terminal from the
Linux programs menu in the lower left corner of the GUI.
11.2 Linux Login & Terminal Window (Remote Connection)
To login to the DSV-J2 from a remote computer, you need to use a “ssh” – a secured shell
terminal.
11.2.1 Remote Login From a Linux PC
To login to the DSV-J2 remotely, you need to know the IP address of the DSV-J2 that you want
to connect to.
From a Linux PC terminal command line,
type: ssh <DSV-J2 IP address> <enter>
An example would be:
type: ssh 192.168.100.50 <enter>
This will bring up the login window on the remote DSV-J2. Login as follows:
login name: root <enter>
password: xxxxx <enter> // consult your system administrator to know the root
password or Doremi to know the default root password
You should now be connected to the selected DSV-J2 remotely.
DSV.OM.000391.DRM Page 43 of 68 Version 1.3
Doremi Labs