BECKHOFF ET9300 - Manual (Page 54)

52 Application Note ET9300
Figure 10: EoE EtherCAT Slave Settings
4.) Set network at least to PRE-OP (mailbox communication needed)
5.) Open a program supporting PING service
6.) Ping device
Figure 11: Ping Command Window
8.2.2.2 EoE Example 2
The prerequisite for this example are the steps described in the introduction of chapter 8.2.2 EoE
Examples.The example describes how to ping an EtherCAT slave device from a remote PC (Figure
12: EoE Example 2 (Schema)).