Ivoclar Vivadent IPS e.max CAD Labside - Manual (Page 22)

22
Combination firing (Crystallization and Stain/Glaze firing in one step)
Before crystallization, IPS e.max CAD Crystall./Glaze, Shades and Stains are applied.
– IPS e.max CAD Crystall./Shades are ready-to-use “Dentin and Incisal” stains in syringes
– IPS e.max CAD Crystall./Stains are ready-to-use intensive stains in syringes
– IPS e.max CAD Crystall./Glaze Paste is a ready-to-use glazing paste
Shade
Incisal 1
Shade
Incisal 2
Shade 0 Shade 1 Shade 2 Shade 3 Shade 4 white cream sunset copper olive khaki mahogany
IPS e.max CAD Crystall./Shades IPS e.max CAD Crystall./Stains
Please observe the following procedure:
– Hold the restoration by the firing pin and apply IPS e.max CAD Crystall./Glaze Paste evenly on the entire restoration
using a brush.
– Hold inlays, onlays or veneers with an OptraStick or diamond tweezers when applying IPS e.max CAD Crystall./Glaze
Paste, or directly apply paste while the restoration is seated on the die.
– If a slight thinning is desired, the glaze may also be mixed with a little IPS e.max CAD Crystall./Glaze Liquid.
– Avoid applying too thick a glaze layer. Avoid pooling, especially on the occlusal surface.
– Too thin a glaze layer may lead to an unsatisfactory gloss.
– If characterizations are desired, the restoration can be individualized using IPS e.max CAD Crystall./Shades and Stains
before Crystallization firing.
– Extrude Shades and Stains from the syringe and mix thoroughly.
– The Shades and Stains may be slightly thinned using IPS e.max CAD Crystall./Glaze Liquid. However, the consistency
should still remain pasty.
– Apply mixed Shades and Stains directly into the unfired glaze layer using a fine brush.
Procedure for partial crowns,
anterior crowns, posterior crowns
Procedure for veneers, inlays, onlays
Hold the restoration by the firing pin and apply IPS e.max CAD
Crystall./Glaze Paste evenly on the blue restoration Secure inlays, onlays on an OptraStick for the application of
IPS e.max CAD Crystall./Glaze Paste, Shades and Stains
Apply the mixed IPS e.max CAD Crystall./Shades and Stains directly into the
unfired IPS e.max CAD Crystall./Glaze Paste