Ivoclar Vivadent IPS e.max CAD Labside - Manual (Page 39)

39
C
u
t-
B
a
ck
Te
ch
n
iq
u
e
Coat the inner surfaces of the ceramic restoration with IPS Natural Die Material Separator and allow it to react for a short time
Die fabrication with IPS Natural Die Material
The light-curing IPS Natural Die Material simulates the shade of the preparation. Fabricate a die according to the shade
information supplied by the dentist (shade selection), which serves as the optimum basis for a true-to-nature shade repro-
duction of the given oral situation. Please observe the following procedure:
– Coat the inner surfaces of the ceramic restoration with IPS Natural Die Material Separator and allow it to react for a
short time.
– Apply the selected IPS Natural Die Material on the inner aspects of the restoration using the IPS Condenser. Make sure
that the entire inner aspect is covered and filled.
– Insert the IPS Die Holder into the material and adapt excess around the die holder. Make sure that there is no gap at the
restoration margins.
– Cure the IPS Natural Die Material die in a customary light-polymerization device for 60 seconds.
– If necessary, the die can be further finished and smoothed after polymerization.
Completely fill the restoration, insert the IPS Die Holder into the material, adapt excess around the die holder, and cure in a customary light polymerization device
A die made of IPS Natural Die Material provides the optimum basis for true-to-nature all-ceramic restorations