Ivoclar Vivadent IPS e.max CAD Labside - Manual (Page 32)

Once the IPS e.max CAD restoration has cooled to room temperature, proceed with the following steps:
– Remove the restoration from the hardened IPS Object Fix Putty or Flow.
– Remove any residue with ultrasound in a water bath and/or with steam.
– Do not blast the framework with Al
2
O
3
or glass polishing beads.
– Place the restoration on the model, check fit and make slight adjustments, if necessary.
– If adjustments by grinding of the restoration are required, make sure that no overheating of the ceramic occurs.
Remove residue with ultrasound in a water bath… … or with steam.
Do not blast the restoration with Al
2
O
3
or glass polishing beads
32