Leprecon LP-X24 Manual v3.2 - Manual (Page 106)

102 Chapter Four Moving Light Programming
LP-X24 and LP-X48 Users Manual
For example, select all instruments and change the Intensity.
4. Press the Save softkey.
5. Repeat steps 2 through 4 for each look you want to modify.
6. When you are done, bring the Programmer Fader to zero.
7. Return to Run mode.
To Modify a Conventional Light Look When You are Running a
Show
Blind Edit
This operation will work on any playback except one that is in page hold mode. For
example, if you are running a scene list on Page 1, Playback 1, you will not be able to
edit a scene list on Page 2, Playback 1. This is because Playback 1 is in page hold
mode and will not switch to Page 2 until the Playback 1 level is brought to zero.
1. Start by ensuring that all buttons and faders are in the proper positions.
Button/Fader Setting
Modes Edit and Scene
Display ML
Filter
ML or BOTH
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Down
Edit Mode
playback & stack select buttons.
Please select a scene to edit using the
2. Press the Select button for the playback repeatedly until you reach the look you
want to edit.
The LP-X displays information for that look of the playback.